4
WARNING: PROPER USE
Any unauthorized modifications to or use of this engine outside its specified
mechanical, electrical, or other operating limits may cause personal injury
and/or property damage, including damage to the engine. Any such
unauthorized modifications: (i) constitute "misuse" and/or "negligence"
within the meaning of the product warranty thereby excluding warranty
coverage for any resulting damage, and (ii) invalidate product certifications
or listings.
CAUTION: POSSIBLE DAMAGE TO ENGINE OR PROPERTY
CAUTION: BATTERY CHARGING
To prevent damage to a control system that uses an alternator or battery-
charging device, make sure the charging device is turned off before
disconnecting the battery from the system.
CAUTION: ELECTROSTATIC DISCHARGE
Electronic controls contain static-sensitive parts. Observe the following
precautions to prevent damage to these parts.
-Discharge body static before handling the control (with power to the control
turned off, contact a grounded surface and maintain contact while handling
the control).
-Avoid all plastic, vinyl, and Styrofoam (except antistatic versions) around
printed circuit boards.
-Do not touch the components or conductors on a printed circuit board with
your hands or with conductive devices.
CAUTION: WELDING When welding on the vessel, disconnect the
battery switch along with the connectors for the Engine Control Module
(ECM). If left connected there is a chance of damage to the ECM.
To Next Page
Loading...
Need help?
General
