KODIAK K16 2
Questions? Call 855-965-0011 Use OEM Parts
SERIAL NUMBER
This manual is furnished with each new machine. This manual will allow the Operator to get the best performance out of
your RPS manufactured Scrubber-Drier, Sweeper, Burnisher, or Orbital Scrubber. Read this manual thoroughly before
operating or servicing the machine.
This machine will provide excellent performance, but the best results will be obtained at the most minimum costs if:
• The machine is regularly maintained - per the Authorized Local Distributor.
• The machine is operated with reasonable care and caution.
• The machine is maintained with manufacturer supplied parts.
Locate Serial Number
The serial number of your machine is located on the lower half of the control panel of the machine.
AS OUR POLICY IS ONE OF CONSTANT IMPROVEMENT - ALL INFORMATION AND
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Intended use
The Kodiak K16 walk-behind scrubber is intended for commercial applications with hard floor surfaces such as concrete,
VCT, tile and grout, stone, ect. This machine is not designed to clean carpets or sand wooden surfaces. Use only OEM
pads/brushes and commercially available floor cleaning detergents. Do not use this machine other than described in this
Operator Manual.
INTRODUCTION
Fill out while installing machine for future reference.
Model No. - ______________________________
Serial No. - ______________________________
Installation Date - _________________________
Machine Data Uncrating Machine
Inspect machine for damage before unloading, if any damage
has occurred report it to the carrier. Contact distributor or RPS
Corp. for missing components.
Remove protective shipping frame then locate and unscrew
the metal bracket connecting the machine to the pallet. Before
removal the scrub head should be in the raised position. Using
the supplied ramp carefully back the machine off the pallet.
DANGER DECAL P# 260-2021
To Next Page
Loading...
Need help?
General