13
Parts and Service
Replacement parts can be obtained through your local Kodiak engine dealer.
Kodiak dealers are equipped to perform major and minor repairs. They are anxious
to see that all of your maintenance and service needs are quickly and courteously
completed. Please contact KEM Equipment Inc./Kodiak Marine regarding any
favorable or un-favorable experiences with our service dealers.
The engine model number and serial number will be required when seeking
information and/or ordering parts. There is a list of service dealers located at the
very end of this manual.
Technical support for Kodiak Marine engines can be obtained by contacting KEM
Equipment Inc.
Service Literature
By contacting our Parts Department you can purchase parts and service manuals
for Kodiak Marine engines. 503-692-5012
WARNING: The bilge can accumulate explosive fumes. The bilge
blower will evacuate the fumes. The bilge blower must be run for a minimum
of 10 minutes prior to cranking the engine.
WARNING: Do not start or run the engine in a closed or poorly
ventilated area where exhaust gases may accumulate. All internal
combustion engines give off various fumes and gases while running. Avoid
breathing these gases as they may contain poisonous carbon monoxide and
other gases, which can endanger your health or life if inhaled steadily for a
few minutes.
CAUTION: If the engine stalls or falters during starting, wait 3 to 4
seconds before reengaging the starter. This will prevent possible damage
to the starter or the engine. Do NOT operate the starter for periods longer
than 5-8 seconds at a time. An interval of at least 1 minute should be
observed between cranking periods to protect the starter from overheating.
To Next Page
Loading...
Need help?
General
