14
PRE-OPERATIONAL INSPECTION
WARNING: Remove the key from the ignition prior to any engine
check or operation. Do not energize any engine prior to performing any of
the following.
Your KODIAK Marine Engine was inspected and test ran before leaving the
factory. Before operating a new engine, you must follow any pre-operational
instruction.
1. Open the engine hatch cover and let the compartment air out for at least ten
minutes.
2. Always make sure you are working in a well-ventilated area when around
gasoline.
3. Check engine oil level, remove dipstick wiping clean, and recheck your oil level.
4. Inspect the oil and fuel filters for tightness and make sure there are no leaks
around these filters.
5. Check coolant level – refill to the appropriate levels.
6. Check for any oil, coolant, or fuel leaks.
CAUTION: Follow any leaks and repair any abnormal leakage before
continuing.
7. Inspect the battery connections for corrosion, clean as necessary.
8. Check the battery fluid level and state of charge, fill as needed.
9. Inspect the spark arrester for any obstructions (Bugs, leaves etc.,) clean or
replace as needed.
10. Check coolant Hoses for Leaks (follow any leaks and repair).
NOTE: It is suggested to use Baking Soda and water to safely clean any
corrosion around the Battery connections.
NOTE: If the engine is equipped with a stern or jet drive it must be in neutral
prior to starting the engine. Starting the engine with the drive engaged
imposes unnecessary strain on the battery, starter and driven components.
Inspect the spark arrester for any obstructions (bugs, leaves etc.). Clean or
replace as needed.
To Next Page
Loading...
Need help?
General
