9. Check the Installation
NOTE: Cov
ering the seat with plastic wrap is optional. The features can be tested
while siing on the cleansing seat or covering the wand with your hand.
NOTE: When testing the features, apply pressure to the right side (facing the toilet)
of the seat. The features will not activate if there is no pressure on the seat.
Wrap the seat with plastic wrap. This will prevent water from spraying beyond
the toilet while testing.
Plug the power cord into the electrical outlet. The seat will go through a power-up
sequence. The seat will go silent when the pow
er-up is complete.
Refer to the Homeowners Guide to test the seat features.
Kohler Co. 13
1354689-2-D