2. Install the Remote Dock
1/16" or 1/4"
Holes
Remote Dock
Position the remote dock at the desired mounting location.
Conrm that the remote dock is lev
el.
Using a pencil, mark the two mounting-hole locations. Set the remote dock aside.
For installation into a stud or other wood surface: Drill a 1/16" hole at each of the
marked locations.
For installation using wall anchors: Drill a 1/4" hole at each of the marked
locations. Install the provided w
all anchors into the holes.
Position the remote dock over the anchors or marks. Secure the remote dock with
the provided screws.
Open the baery compartment on the remote control.
Install the four provided AA baeries in the orientation shown.
Place the remote control on the remote dock.
1354689-2-D
6 Kohler Co.