Position (a): RAISE
When the multifunction mono-lever is pulled further from the
“RAISE” position, the lever stops in that position.
The boom stops at the preset position and the lever returns to
“HOLD” position at the same time when the remote boom posi-
tioner is enabled.
The boom stops at the highest position and the lever returns to
“HOLD” position at the same time when the remote boom posi-
tioner is disabled.
Position (b): HOLD
The boom and fork remain in the positions where they are stopped.
Position (c): LOWER
Position (d): FLOAT
The boom moves freely under external force.
Position (e): TILT
When the multifunction mono-lever is pulled further from the
“TILT” position, the lever stops in that position. As soon as the
fork reaches the position preset by the fork positioner, the lever
returns to the “HOLD” position.
Position (f): DUMP
ATTACHMENT SELECTOR SWITCH
The attachment selector switch is used to switch the bucket po-
sitioner and fork positioner.
When using the fork, set it to (B) position.
(A) Bucket positioner
Set to this position when using the bucket.
(B) Fork positioner
Set to this position when using the fork.
MACHINE OPERATIONS AND CONTROLS
The operation speed is determined by the terrain, ground condition, load volume, type of load, and how large
the jobsite is.
Keep the engine speed almost maximum during the operation. Use the 1st or 2nd in the speed range for opera-
tion.
Use the 3rd or 4th in the speed range when traveling without load.
ATTACHMENTS AND OPTIONS HANDLE FORK
6-9
To Next Page
Loading...
Need help?
General
