bizhub C360i/C300i/C250i 1-17
1.6 Special notice to user
1
or a qualified installer.
The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other
electronic device, including FAX machines, to send any message unless such message clearly contains in a
margin at the top or bottom of each transmitted page or on the first page of the transmission, the date and
time it is sent and an identification of the business or other entity, or other individual sending the message
and the telephone number of the sending machine or such business, other entity, or individual. (The tele-
phone number provided may not be a 900 number or any other number for which charges exceed local or
long-distance transmission charges.)
In order to program this information into your FAX machine, you should complete the following steps: See
Sending by Renaming the Sender ([Fax Header Settings]), of the User's Guide [Fax].
WARNING/CAUTION Explained
7WARNING
- The exclamation point within an equilateral triangle followed by the word "Warning" is intended to alert
the user to the possibility that a disregard for the warning may result in fatal hazards or critical injuries.
Be sure to focus your attention on the Warning headings when reading this Quick Guide.
7CAUTION
- The exclamation point within an equilateral triangle followed by the word "Caution" is intended to alert
the user to the possibility that a disregard for the caution may result in minor injuries or in physical dam-
age. Be sure to focus your attention on the Caution headings when reading this Quick Guide.
For Europe
The Facsimile has been confirmed to meet the standards (or requirements) ETSI for pan-European single ter-
minal connection to the public switched telephone network (PSTN).
For New Zealand
This device is equipped with pulse dialing while the Telecom standard is DTMF tone dialing. There is no guar-
antee that Telecom lines will always continue to support pulse dialing.
Use of pulse dialing, when this equipment is connected to the same line as other equipment, may give rise
to bell tinkle or noise and may also cause a false answer condition. Should such problems occur, the user
should not contact the Telecom Fault Service.
This equipment may not provide for the effective hand-over of a call to another device connected to the same
line.
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that
the item complies with minimum conditions for connection to its network. It indicates no endorsement of the
product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any
item will work correctly in all respects with another item of Telepermitted equipment of a different make or
model, nor does it imply that any product is compatible with all of Telecom’s network services.
The automatic calling functions of this equipment must not be used to cause a nuisance to other customers.
Telepermitted equipment only may be connected to the auxiliary telephone port. The auxiliary port is not spe-
cifically designed for 3-wire connected equipment. 3-wire might not respond to incoming ringing when con-
nected to this port.
To Next Page
Loading...
Need help?
General
