3
F 088
Claris –Aqua Filter System Cartridge (not supplied) -
Fig. 28.
X
S 4000 KRUPS
C
leaning fluid for Cappuccino system (not supplied) -
F
ig. 29.
X
S6000
A
uto-Cappuccino Set (not supplied) -
F
ig. 30.
F 054
Descaling powder (one sachet supplied) -
Fig. 31.
XS 3000
Packet of 10 cleaning tablets (two tablets supplied) -
Fig. 32.
This machine must only be used with Krups' accessories for the guarantee to be valid.
Measuring water hardness
Before using the appliance for the first time or if you have noted a change in water hardness, it is advisable to adapt the
appliance to the water hardness. To determine the water hardness, use the measuring stick delivered with your appliance
or get in contact with your water authority.
Fill a glass with water and immerse a stick into it.
After 1 minute the hardness measurement will appear (moderately hard water)
- Fig. 1 et 2
.
To get the best taste from your coffee and extend your appliance’s service life, we advise you to use only the Claris - Aqua
Filter System cartridge sold as an accessory.
Fig. 3 :
Mechanism to indicate the month the cartridge was fitted and when to replace it (after 2 months at most).
Installing the cartridge in the machine. On first use, screw the filter cartridge into the bottom of the water tank
- Fig. 4
.
Place a receptacle under the steam nozzle. Run 300 ml of water by pressing the rinse button once for more than 3 seconds.
You can repeat this operation if you wish.
Settings
Connect the appliance to the mains power supply but do not turn it on.
Lift the cup grid by pressing on the back to make it tilt.
Press the ‘
Service
’ and keys at the same time
- Fig. 5
.
The digital display for parameter setting is under the servicing flap
- Fig. 6
.
Look down vertically to the bottom of the window
- Fig. 7
.
ACCESSORIES (SOLD SEPARATELY)
DESCRIPTION
BEFORE FIRST USE
Degree of
hardness
0
Very soft
1
soft
2
moderately hard
3
hard
4
extremely hard
° f
< 5,4° > 7,2° > 12,6° > 25,2° > 37,8°
° dH
< 3° > 4° > 7° > 14° > 21°
° e
< 3,75° > 5° > 8,75° > 17,5° > 26,25°
Settings
01 2 34
The Claris cartridge needs to be replaced after about every 50 litres of water or every two months at least.
A
Water tank handle/lid
B
W
ater tank
C
Special maintenance instructions
D
Cleaning tray
E
Coffee grounds collector
F
Coffee outlets with height adjusting handle
G
Removable drip grid and tray
H
Coffee bean container lid
Coffee bean container
I
Grinding fineness setting knob
J
Metal grinding wheel
K
Cleaning inlet
L
Digital display for parameter setting
M
Cup tray
C
offee volume rotating knob
N
S
team button
O
“On/Off” key and light
P
Coffee volume rotating button
Q
"
empty the coffee grounds" and "empty the
drip tray" warning light
R
“Fill water tank” light
S
Strong coffee key
T
Standard coffee key
U
“Scale removal” light
V
“Clean” light
W
“Rinsing/servicing” key
X
Steam nozzle
Y
Water level floats
1
2
EN
To Next Page
Loading...
Need help?
General
