Krups EA80 series User Manual

7
3 - Second rinsing ± 5 mn
T
he ‘
c
lean
’
light again becomes steady. A second cleaning cycle will be run automatically. This second rinsing
cycle lasts about 5 minutes. Once the second rinsing cycle has finished, the ‘
clean ’ light will go off.
Remove and empty your waste water receptacle.
Empty the drip tray and fit it again.
Fill your water tank.
Y
our appliance will be ready for use again.
Only use KRUPS (XS3000) cleaning tablets. We cannot be held responsible for any damage that may result from the use
of tablets from other brands.
You can obtain cleaning tablets from KRUPS Service Centres.
Scale removal program – total duration: about 22 minutes.
The quantity of scale deposited depends on the hardness of the water used. The appliance will automatically warn you by
the ‘
calc ’ light coming on when you need to proceed with scale removal.
This program is only accessible when the machine requests it.
Caution! To benefit from the guarantee conditions, it is essential to perform the appliance scale removal cycle
when informed to do so. Be sure to follow the procedure closely step by step. You can continue to use the
appliance when the light is on, but you are advised to perform the program as soon as possible.
If your appliances fitted with our Claris - Aqua Filter System F088 cartridge, please remove the cartridge during
the descaling operation.
Make certain to protect your work surface during cleaning and scale removal cycles, especially if it is made
of marble, stone or wood.
Press the ‘ Service ’ key to start up the scale removal program. The ‘ calc ’ and lights will flash.
Remove and clean the drip tray.
Place a receptacle with a minimum water capacity of 0.6 l under the coffee outlets and under the steam nozzle.
Empty the tank and fill it with lukewarm water up to the ‘calc’ marking.
Dissolve a sachet of
Krups scale remover F054 (40 g).
Only use KRUPS scale removal products. You can obtain scale removal products from KRUPS Service Centres.
The manufacturer may not be held responsible for damage to the appliance through use of other products.
Put the water tank back in place. The light turns off and the ' calc ' light stops blinking.
Press the '
Service ' button after having carried out all of these operations.
1 - Descaling cycle ± 10 mn
The ' calc ' light stops blinking. The descaling cycle starts and is carried out automatically. The pump occasionally
sucks up water which comes out of the coffee nozzles and then the steam nozzle. This operation lasts
approximately 10 minutes.
When the cycle has completed, the and ‘
calc ’ lights blink.
2 - First rinsing ± 6 mn
A first rinsing is needed to eliminate the remaining scale remover. This cycle is run automatically. It lasts about 6
minutes.
Empty your receptacle full of waste water.
Empty the drip tray and then put it back again together with the receptacle as previously.
Empty, clean and rinse the water tank and then fill it again up to the “Max. level.
Replace your water tank. The ‘
calc ’ light will flash and the light will go off.
Press the ‘ Service ’ key. The ‘ calc ’ light will become steady. The automatic cycle will last 6 minutes.
3 - Second rinsing
At the end of the first rinsing, the ‘ calc ’ light will flash. A second automatic cycle will last 6 minutes.
Remove your waste water recipient and the drip tray then fit them again.
Again press the ‘
Service ’ key. The ‘ calc ’ light will become steady.
A second automatic cycle will last 6 minutes.
Once the second rinsing is finished, the ‘
calc ’ light will go off.
Empty the drip tray and then fit it again.
Empty and then fill your water tank.
Your appliance is now ready for use again.
I
f there is not enough water in the water tank when you start the program, the light will come on to warn you. Add
the appropriate amount of water to the container and cleaning will continue automatically.
I
f your machine is unplugged during cleaning or in the event of power failure, you will have to restart the cleaning
program right from the start. This is essential due to water circuit rinsing reasons. In this case, you will need to use
another cleaning tablet. Be sure to complete the entire cleaning cycle to avoid any risk of irritation (seek medical
a
dvice if cleaning solutions are accidently swallowed.
The cleaning cycle is a continuous cycle. Do not put your hands under the coffee outlets during the cycle.
EN
KR_ESPRESSO_EA80_EE_OA21003_Mise en page 1 09/12/13 13:58 Page7

Krups EA80 series Specifications

General

Brand	Krups
Model	EA80 series
Category	Coffee Maker
Language	English