KRUPS Espresseria Automatic
14 Use and maintenance / SERIE EA 80xx
3.2 Preparing the appliance
Before switching on the appliance, carry
out the following steps.
Caution : Water tank (14): Do not
fill the tank with hot water, mineral water,
milk or any other liquid as this could da-
mage the appliance.
Coffee bean holder (19): Do not put
ground coffee or water into the coffee
bean holder as the grinder could be da-
maged. Ensure that no foreign particles
(e.g. small stones in the coffee beans)
get into the holder as they could damage
the grinder (not covered by the guaran-
tee!).
Drip tray (27): To avoid the risk of burns
due to hot water splashing, check that
the drip tray is fitted correctly!
Remove the water tank (14) and fill it with
cold water.
Tip : You can fill the tank without removing it:
open the lid and pour in the water using a sui-
table recipient.
i
Important: Respect the maximum filling
level (reference "Max") of the water tank.
!
Fit it and close the lid.
Note : If, when the appliance is switched
on, the water tank is missing or does not
contain enough water (under the refe-
rence "Calc"), the message "Fill the tank"
will be displayed and it will not be possi-
ble to prepare espresso or coffee.
!
Open the lid (16) of the coffee bean hol-
der (19) and fill it with coffee beans (max.
275 g).
Close the lid of the coffee bean holder.
To Next Page
Loading...
Need help?
General
