24
You can stop your appliance at all times: the appliance will emit two beeps and then it will
stop soon afterwards.
PROBLEMS AND CORRECTIVE ACTIONS
PROBLEMS CORRECTIVE ACTIONS
The appliance does not
switch on when the “On/Off”
is pressed.
Check that the plug of the power cord is pushed
correctly into the mains socket.
Water or steam comes
incorrectly out of the steam
nozzle.
In case of repeated operation, several drops may drip
from the steam nozzle.
The espresso or coffee is not
hot enough.
Change the coffee temperature setting.
Heat the cups by rinsing them with hot water.
The coffee is too light or not
strong enough.
Check that the coffee bean tank has coffee in it and that
it is owing correctly. Avoid using oily, caramelised or
avoured coffee.
Reduce the volume of coffee using the central knob.
Turn the grinding neness knob towards the left for
a ner grind. Prepare in two cycles using the 2 cup
function.
The coffee ows too slowly.
Turn the grinding neness knob towards the right for a
coarser grind (may depend on the type of coffee used).
Carry out one or two rinsing cycles.
The coffee is not creamy
enough.
Turn the grinding neness knob towards the left for a
ner grind (may depend on the type of coffee used).
Change the Claris Aqua Filter System cartridge (follow
the installation procedure on page 13).
Carry out one or two rinsing cycles.
The appliance does not serve
any coffee.
An incident has been detected during the preparation.
The appliance resets itself automatically and is then
ready for a new cycle.
Why can I not run descaling/
why does my machine not
request a descaling cycle?
The machine only requests a descaling cycle once it has
made a certain number of drinks using steam.
You have used ground coffee
instead of bean coffee.
Use your vacuum cleaner to suck out the pre-ground
coffee in the coffee bean tank.
The grinder makes a strange
noise.
There are foreign particles in the grinder. Contact
KRUPS’ Customer Service.
The grinding neness knob is
hard to turn.
Only change the grinder setting when it is operating.
To Next Page
Loading...
Need help?
General
