KRUPS SERIE EA90
14
n If the tray is dirty, clean it under running water. If the metal contacts are dirty, clean by scrubbing
them under water. Wipe the metal contacts dry before putting them back in the machine.
n The drip trays will be separated when you empty them. Avoid spilling water as much as possible on
the metal contacts located at the end of the drip tray.
n If the machine asks you to empty the drip tray when it is empty, check whether the metal contacts
at the back of the drip tray are clean and thoroughly dry.
At each stage check the messages on the touch screen
n Empty the drip tray
Open the left door. Remove the used coffee collector by
pulling it towards you.
Empty the used grounds.
Replace the used coffee collector.
h
n Emptying the used coffee collector
Caution: Do not wash it in the dishwasher.
!
Remove the drip tray. Empty the drip tray.
Wipe the metal contacts.
Replace the drip tray.
h
h
n Open the left door (15). Remove the used coffee
collector (5). Empty and clean it before putting it
back in place.
Your machine has a drip tray (6).
n The drip tray collects waste water and is equipped with an overflow detection sensor.
n When it needs to be emptied, the request will be made on the screen.
n The cover of this tray is necessary to avoid excessive condensation and water spills.
Caution: The cover and the grid can fall when you empty the drip tray.
!
n Adjusting the coffee nozzle height
h
h
Your machine is supplied with two cups only which can be used
for cappuccino or a caffe latte.
IFU_EN_KR_COFFEEMAKER_8020000082.qxp_Mise en page 1 22/05/2017 17:22 Page14
To Next Page
Loading...
Need help?
General
