KRUPS SERIE EA90
28
n Hot water
1
n Press the “Hot water” button on the touch screen.
n If the machine detects no water when you request this recipe, it will ask
you to fill the tank.
3
n Fill the cup with the volume of milk indicated on the screen and
place it under the coffee spouts.
n The cup must be placed close to the cleaning container, under the steam
nozzle, at the back of the niche.
n However, do not press the cleaning container (11) with the cup; otherwise,
it might break off.
n You can lower or raise the coffee nozzle to suit the size of your cup. The
steam nozzle will descend just behind the coffee nozzles. Caution: the
maximum height of the cup is defined by the coffee nozzles; do not tilt the
cup to place it under the coffee nozzles.
n To use a large cup (or mug), you might have to remove the small drip tray (6).
n Press the “OK” button.
4
n Milk preheating phase.
n Milk frothing phase:
the milk is then frothed
according to the chosen recipe.
5
n The nozzle moves up and draws back to return to its cleaning
container.
n Remove the cup when the screen shows: Your milk is ready.
n Rinsing the nozzle.
n The nozzle is rinsed automatically. You must wait for this rinsing to be
complete before starting the next preparation.
IFU_EN_KR_COFFEEMAKER_8020000082.qxp_Mise en page 1 22/05/2017 17:22 Page28
To Next Page
Loading...
Need help?
General
