Krups XP320830 User Manual

3
ENGLISH
MAKING ESPRESSO
IMPORTANT!
If the espresso function is used for the first time, the appliance must be
cleaned as described in the "FIRST USE" paragraph.
IMPORTANT! To prevent splashes of hot water, check that the filter holder
has been tightened until it stops before preparing the coffee. Do not
remove the filter holder while the water is flowing, as the appliance is still
under pressure.
With ground coffee
The type of coffee you choose will determine the strength and taste of your espresso: the
ner your ground coffee, the more intense your espresso will be.
 Fill the water tank with tepid water and ret it on the appliance, making sure that it is
correctly in place.
Ensure you have removed the red protective cap from under the water tank (1).
– Remove the water tank (A) and ll it. The water level should not exceed the "MAX" mark
on the tank and should contain at least 300 ml (= equivalent to 2 large cups (2-3). Then
replace the water tank, ensuring that the cover is closed. (4).
– Plug in your machine. (5).
– Press the On button (C)(6). On the control panel (D), the "On" indicator light switches
on (D2) (7).
– The selection button (D.1) must be set to the espresso position – (button not
depressed) (D.1.1) (8).
– Place a lter without coffee (F1) into the lter holder (F) (9). Slot the lter holder into
place (E) and turn it to the right until it stops (10). Place a receptacle under the lter
holder (11).
– When the espresso preheating indicator light (D2.1) switches on, turn the thumb
wheel (D.3) to the left, to espresso preparation (D.3.2) (12-13) - The ow will start after
approximately ten seconds.
– Let approximately 300 ml of water trickle out (change the receptacle if necessary) (14),
then turn the thumb wheel to position O (D.3.1) to stop preparation (15).
– IMPORTANT / After 25 minutes of disuse, your appliance will switch off automatically
as a safeguard.
2. RINSING THE STEAM SYSTEM
Remove the water tank and ll it. The water level should not exceed the "MAX" mark on
the tank and should contain at least 300 ml (= equivalent to 2 large cups). Then replace the
water tank, ensuring that the cover is closed.
The selection button (D.1) must be set to the steam position (button depressed)
(D.1.2) (16)
Place the nozzle into a container lled with water (G.1) (17).
When the steam preheating indicator light (D2.2) switches on (18), turn the thumb wheel
(D.3) to the right, to the steam function (D.3.3) (19).
Let the water heat for 20 seconds (20) then turn the thumb wheel to position O (D.3.1) to
stop the steam (21). Return the selection button (D.1) to the espresso position (D.1.1) (26).

Krups XP320830 Specifications

General

Brand	Krups
Model	XP320830
Category	Coffee Maker
Language	English