CLEANING 206
13.1Cleaning motorcycle
Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
– Never clean the vehicle with high-pressure cleaning equipment or a strong water-jet. The excessive pressure can penetrate electrical
components, plug connectors, Bowden cables and bearings, etc., and can damage or destroy these parts.
Warning
Environmental hazard Problem materials cause environmental damage.
– Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc., according to regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
– Before cleaning, seal the exhaust system to prevent water from entering.
– Remove loose dirt first with a soft jet of water.
– Spray very dirty parts with a normal commercial engine cleaner and then brush off with a soft brush.
Motorcycle cleaner ( p. 230)
Info
Use warm water mixed with a normal commercial engine cleaner and a soft sponge.
If the vehicle has been used on salted roads, clean it with cold water. Warm water intensifies the effects of salt.
– After cleaning the motorcycle thoroughly with a soft jet of water, dry it with compressed air and a cloth.
To Next Page
Loading...
Need help?
General
