KTM 125 SX 2019 User Manual

11 SERVICE WORK ON THE CHASSIS
76
L01223-10
– Now inject the liquid into the system until it emerges from the
drill hole
6
of the master cylinder without bubbles.
– Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
– Remove the bleeding syringe. Mount and tighten screws
bleeder screw.
– Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
– Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.

KTM 125 SX 2019 Specifications

General

Displacement	124.8 cm³
Starter	Kickstarter
Transmission	6-speed
Fuel System	Mikuni TMX 38
Front Brake	Disc brake
Rear Brake	Disc brake
Ground Clearance	375 mm
Seat Height	950 mm
EMS	Kokusan
Engine Type	1-cylinder, 2-stroke
Bore x Stroke	54 mm x 54.5 mm
Rear Suspension	WP shock absorber with linkage
Fuel Tank Capacity	7.5 l
Clutch	Wet, multi-disc clutch, Brembo hydraulics
Frame Design	Central tube frame made of chrome molybdenum steel