16 COOLING SYSTEM
180
S04240-10
Main work
– Position the motorcycle upright.
– Position an appropriate container under the engine.
–
Remove screw
1
with the seal ring.
– Remove the radiator cap.
– Completely drain the coolant.
–
Mount and tighten screw
1
with a new seal ring.
Guideline
Screw plug, water
pump drain hole
M6 10 Nm (7.4 lbf ft)
16.5 Filling/bleeding the cooling system
Warning
Danger of poisoning Coolant is toxic and a health hazard.
– Keep coolant out of the reach of children.
– Do not allow coolant to come into contact with the skin, the eyes and clothing.
– Consult a doctor immediately if coolant is swallowed.
– Rinse the affected area immediately with plenty of water in the event of contact with the skin.
– Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
– Change clothing if coolant spills onto your clothing.
To Next Page
Loading...
Need help?
General
