3 WORK
15
3.8 Installing the start number plate
F00013-10
– Connect the brake line at the start number plate.
– Position the start number plate.
The holding lugs engage in the fender.
–
Mount and tighten screw
1
.
3.9 Removing the seat
F00017-10
–
Remove screws
1
.
– Raise the rear of the seat, pull the seat back, and lift it off.
3.10 Mounting the seat
F00016-10
– Mount the front of the seat on the collar bushing of the fuel
tank, lower the seat at the rear, and push the seat forward.
– Make sure that the seat is correctly locked in.
F00017-10
–
Mount and tighten screws
1
.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
To Next Page
Loading...
Need help?
General
