12 SERVICE WORK ON THE CHASSIS 73
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
– Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
B01531-11
Main work
– Check the throttle cable routing. ( p. 77)
– Position the fuel tank and fit the two spoilers to the sides of the radiator bracket.
– Make sure that no cables are trapped or damaged.
– Mount the fuel tank breather.
– Mount and tighten screw 1 with the rubber bushing.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
B01530-11
– Position the horn, and fit and tighten screws 2 with collar bushings.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
B01533-10
– Connect the electrical plug-in connection 3.
– Remove the wash cap set.
– Thoroughly clean the plug-in connection of the fuel line using compressed air.
Info
Never let dirt enter the fuel line. Dirt in the fuel line clogs the injection
valve.
– Lubricate the O-ring and connect plug-in connection 4 of the fuel line.
Info
Route the cable and fuel line at a safe distance from the exhaust system.
Finishing work
– Mount the seat. ( p. 68)
12.36 Checking for chain dirt accumulation
400678-01
– Check the chain for coarse dirt accumulation.
» If the chain is very dirty:
– Clean the chain. ( p. 74)
To Next Page
Loading...
Need help?
General
