SERVICE WORK ON THE CHASSIS 39
100916-11
– Position the exhaust manifold.
– Attach springs .
Spring hooks (50305017000)
– Mount and tighten screw .
Guideline
Remaining screws, chassis M8 25 Nm
(18.4 lbf ft)
100914-11
– Position the angle lever and linkage lever.
– Mount and tighten screw cap .
Guideline
Nut, linkage lever to angle lever M14x1.5 80 Nm (59 lbf ft)
– Mount and tighten screw .
Guideline
Screw, bottom shock
absorber
M10 60 Nm
(44.3 lbf ft)
Loctite
®
2701
– Install the main silencer. ( p. 41)
– Remove the motorcycle from the lift stand. ( p. 31)
10.22Removing the seat
101279-10
– Remove screw .
– Lift up the seat at the rear, pull it back and then remove it from above.
10.23Mounting the seat
B00318-01
– Hook in the front of the seat at the collar bushing of the fuel tank, lower it at the
rear and simultaneously it push forward.
– Make sure that the seat is correctly locked in.
– Mount and tighten the screw of the seat fixation.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
10.24Removing the air filter box lid
100919-10
– Pull off the air filter box lid in area sideways and remove it toward the front.
To Next Page
Loading...
Need help?
General
