SERVICE WORK ON THE CHASSIS 46
B00343-12
– Loosen nut .
– Loosen nuts .
– Adjust the chain tension by turning the adjusting screws left and right.
Guideline
Chain tension 55… 58 mm (2.17… 2.28 in)
Turn adjusting screws on the left and right so that the markings on the left
and right chain adjusters are in the same position relative to the reference
marks . The rear wheel is then correctly aligned.
– Tighten nuts .
– Make sure that chain adjusters are fitted correctly on adjusting screws .
– Tighten nut .
Guideline
Nut, rear wheel spindle M20x1.5 80 Nm (59 lbf ft)
Info
The wide adjustment range of the chain adjusters (32 mm (1.18 in))
enables different secondary ratios with the same chain length.
Chain adjusters can be turned by 180°.
– Remove the motorcycle from the lift stand. ( p. 31)
10.38Checking the chain, rear sprocket, engine sprocket and chain guide
– Raise the motorcycle with the lift stand. ( p. 31)
400227-01
– Shift gear to neutral.
– Check the rear sprocket and engine sprocket for wear.
» If the rear sprocket and engine sprocket are worn:
–
Replace the rear sprocket or engine sprocket. x
Info
The engine sprocket, rear sprocket and chain should always be
replaced together.
400987-10
– Pull on the upper part of the chain with the specified weight .
Guideline
Weight, chain wear measurement 10… 15 kg (22… 33 lb.)
– Measure the distance of 18 chain links in the lower chain section.
Info
Chain wear is not always even, so you should repeat this measurement at
different chain positions.
Maximum distance at the longest
chain section
272 mm (10.71 in)
» If the distance is greater than the specified measurement:
–
Replace the chain. x
Info
When the chain is replaced, the rear sprocket and engine sprocket
should also be changed.
New chains wear out faster on old, worn sprockets.
To Next Page
Loading...
Need help?
General
