KTM 65 SX 2013 User Manual

12 BRAKE SYSTEM 55
100812-10
– Add brake fluid to level A.
Guideline
Dimension A (brake fluid level below
top edge of container)
10 mm (0.39 in)
Brake fluid DOT 4 / DOT 5.1 ( p. 81)
– Position the membrane and the cover with the washer. Mount and tighten the
screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
12.15 Checking the rear brake linings
Warning
Danger of accidents Reduced braking efficiency caused by worn brake linings.
– Change worn brake linings immediately. (Your authorized KTM workshop will be glad to help.)
700424-01
– Check the brake linings for minimum thickness A.
Minimum thickness A ≥ 1 mm (≥ 0.04 in)
» If the minimum thickness is less than specified:
–
Change the rear brake linings. x ( p. 56)
– Check the brake linings for damage and cracking.
» If damage or wear is encountered:
–
Change the rear brake linings. x ( p. 56)
12.16 Removing rear brake linings x
Warning
Danger of accident Brake system failure.
– Maintenance work and repairs must be carried out professionally. (Your authorized KTM workshop will be glad to help.)
Preliminary work
– Raise the motorcycle with a lift stand. ( p. 27)
– Remove the chain guard. ( p. 40)
–
Remove the rear wheel. x ( p. 59)
700428-01
Main work
– Remove lock washer 1.
– Remove screw 2.
700430-01
– Remove the brake linings.
– Clean brake caliper and brake caliper support.

KTM 65 SX 2013 Specifications

General

Brand	KTM
Model	65 SX 2013
Category	Motorcycle
Language	English