ENGLISH
33
Replacing headlight lamp/parking light lamp
Loosen both rubber bands
1
and tilt headlight mask to the front.
Pull the
parking light lamp with holder 2 carefully out of the reflector. Pull
connector
3 off the headlamp and remove rubber cap 4. Disengage
retaining clip and take bulb out of reflector. When changing the parking-
light lamp, simply pull it out of the holder.
Insert the new lamp such that the noses
5 engage in the recesses 6 .When
doing so, do not touch the glass body of the lamp so that it remains free
from fat. Engage retaining clip, mount rubber cap and connector. If the
parking-light lamp is to be replaced, simply insert it in the holder. Reinsert
the parking-light lamp together with the holder.
Engage the bottom end of the headlamp mask at the retaining pins and fix
the mask by means of the rubber bands.
Exchanging the brake light and tail light bulb
Remove the cap
7
on the underside of the license plate retainer.
Turn the lamp socket
8
approximately 30° counterclockwise and pull it out
of the tail light housing.
Slightly depress the bulb, turn it approx. 30° counterclockwise and pull it
out of the socket.
To mount the lamp reverse the worksteps indicated above.
1
5
6
2
3
4
7
8
To Next Page
Loading...
Need help?
General
