ENGLISH
41
Changing oil filter *
Replace the oil filter when changing the engine oil. Press the foot brake
pedal and place a screwdriver or similar between foot brake pedal and
stopper roll so that the oil filter cover is more accessible. Remove banjo bolt
1 and the three screws. Remove oil filter cover 2 and oil filter. Clean the
filter case, oil filter cover and sealing areas. Make sure the oil duct in the oil
filter cover is not clogged.
Place the new oil filter
3 on the connection in the oil filter cover and mount
together with a new seal
4. Tighten the 3 screws in the filter cover to
5 Nm. Tighten the hollow screw with seals and tighten to 15 Nm.
Finally, start the engine and check the oil system for leakage.
1
2
4
3
2
1
To Next Page
Loading...
Need help?
General
