ENGLISH
14
PERIODIC MAINTENANCE SCHEDULE
»
85/105 SX/XC 2008
A CLEAN MOTORCYCLE CAN BE CHECKED MORE QUICKLY WHICH SAVES MONEY
before each
race
1st service after
10 hours
every 20 hours
every 40 hours
at least once
a year
ENGINE
Check gear box oil level
z
Change gear box oil
z z z z
Check spark plugs, adjust distance between electrodes
z z
Renew spark plugs
z z
Clean the spark-plug connector and check for a tight fit
z z z
Check the screws on the kick starter and shift lever for a tight fit
z z z
CARBURETOR
Check the carburetor connection boot and intake flange for cracks or leaks
z z z
Check idle speed setting
z z z z
Check that vent hoses are not damaged or bent
z z z z
ADD-ON-PARTS
Check cooling system for leaks, check quantity of antifreeze
z z z z
Check exhaust system for leaks and fitment
z z z
Check cables for damage, smooth operation, bends; adjust and lubricate
z z z
Check the fluid level in the master cylinder of the hydraulic clutch
z z z z
Clean air filter and filter box
z z z z z
Check electric wires for damage and bends
z z
Check function of electric systems (emergency OFF switch)
z z z
BRAKES
Check brake fluid level, lining thickness, brake lining
z z z
Check brake lines for damage and leaks
z z z
Check/adjust smooth operation and free travel of handbrake/foot brake lever
z z z
Check the screws and guide bolts on the brake system for a tight fit
z z z
CHASSIS
Check shock absorber and fork for leaks and function
z z z z
Clean dust bellows
z z z
Bleed fork legs
z z z
Check swing arm bearings
z z
Check/adjust steering head bearings
z z z
Check tightness of all chassis screws (triple clamps, fork leg axle passage
z z z
axle nuts and screws, swing arm bearings, shock absorber)
WHEELS
Check spoke tension and rim joint
z z z z
Check tires and air pressure
z z z z
Check chain, rear sprockets and chain guides for wear, fitment and tension
z z z z
Lubricate chain, Clean and grease the adjusting screws on the chain tensioner
z z z z
Check clearance of wheel bearings
z z z
The kilometer reading for inspection intervals should not exceed 3 hours.
Maintenance work performed by your authorized KTM workshop is not a substitute for care and maintenance by the driver!
To Next Page
Need help?
General
