ENGLISH
8
OPERATION INSTRUMENTS
»
Kickstarter
The kickstarter is mounted on the right side of the engine. Its upper part can
be swivelled.
Foot brake pedal
The foot brake pedal is located in front of the right foot rest. Its basic posi-
tion can be adjusted to your seat position (see maintenance work).
Plugin- Stand (SX)
The plug-in stand [1] included in the scope of supply can be plugged into the
left side of the bike at the end of the swinging fork.
Side Stand (XC):
Use your foot to swing the side stand forwards to the stop. Make sure it rests
securely on solid ground.
Compression damping of fork
Hydraulic compression damping determines the reaction when the fork is com-
pressed. The degree of compression can be adjusted with adjusting
screws at the bottom of the fork legs.Remove the protecting cap.
Turn the knob [2] clockwise to increase damping, turn it counterclockwise to
reduce damping during compression.
STANDARD ADJUSTMENT
– turn adjusting screw clockwise as far as it will go
– turn it back by as many clicks as are specified for the relevant type of fork
Type WP Suspension 05187D05 15 clicks
Type WP Suspension 05187D06 20 clicks
Rebound damping of fork
Hydraulic rebound damping determines the reaction when the fork is
rebound. By turning the adjusting screw [3] (REB), the degree of damping of
the rebound can be adjusted. Turn the knob clockwise to increase damping,
turn it counterclockwise to reduce damping during rebounding.
STANDARD ADJUSTMENT
– turn adjusting screw clockwise as far as it will go
– turn it back by as many clicks as are specified for the relevant type of fork
Type WP Suspension 05187D05 20 clicks
Type WP Suspension 05187D06 20 clicks
2
2
3
3
1
To Next Page
Loading...
Need help?
General
