17 COOLING SYSTEM
112
V01254-11
– Position the motorcycle upright.
– Position an appropriate container under the engine.
–
Remove screw
1
with the seal ring.
K01374-11
–
Remove radiator cap
2
.
– Completely drain the coolant.
–
Mount and tighten screw
1
with a new seal ring.
Guideline
Screw plug,
water pump
drain hole
EJOTALtracs
®
Plus 60x14
8 Nm (5.9 lbf ft)
Loctite
®
243™
K01375-11
–
Remove bleeder screw
3
.
– Tilt the vehicle slightly to the right.
– Pour in coolant until it emerges without bubbles at the vent
hole, and then mount and tighten bleeder screw
3
immedi-
ately.
Coolant 1.6 l (1.7 qt.) Coolant ( p. 137)
– Completely fill the radiator with coolant. Mount radiator
cap
2
.
– Rest the vehicle on the side stand.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
– Always make sure there is sufficient ventilation
when running the engine.
– Use effective exhaust extraction when starting or
running the engine in an enclosed space.
– Start the engine and run it until the 5th bar of the temperature
indicator lights up.
– Stop the engine and allow it to cool down.
–
After the engine has cooled down, check the coolant level in
the radiator and in the compensating tank again and add more
coolant if necessary.
To Next Page
Loading...
Need help?
General
