20 CLEANING, CARE
120
– After the motorcycle has cooled down, lubricate all moving
parts and pivot points.
– Clean the chain. ( p. 74)
– Treat bare metal (except for brake discs and the exhaust sys-
tem) with a corrosion inhibitor.
Preserving materials for paints, metal and rubber
( p. 139)
– Treat all painted parts with a mild paint care product.
Perfect finish and high gloss polish for paints ( p. 139)
Info
Do not polish parts that were matte when delivered as
this would strongly impair the material quality.
– Treat all plastic parts and powder-coated parts with a mild
cleaning and care product.
Special cleaner for glossy and matte paint finishes, metal
and plastic surfaces ( p. 139)
– Lubricate the ignition/steering lock.
Universal oil spray ( p. 139)
20.2 Checks and maintenance steps for winter operation
Info
If you use the motorcycle in winter, salt can be expected on the roads. You should therefore take precau-
tions against aggressive road salt.
After riding on salted roads, thoroughly clean the vehicle with cold water and dry it well. Warm water
enhances the corrosive effects of salt.
401060-01
– Clean the motorcycle. ( p. 119)
– Clean the brake system.
Info
After EVERY trip on salted roads, thoroughly clean the
brake calipers and brake linings, after they have cooled
down and without removing them, with cold water and
dry them carefully.
After riding on salted roads, thoroughly clean the
motorcycle with cold water and dry it well.
– Treat the engine, the swingarm, and all other bare or zinc-
plated parts (except the brake discs) with a wax-based corro-
sion inhibitor.
Info
Corrosion inhibitor must not come in contact with the
brake discs as this would greatly reduce the braking
force.
– Clean the chain. ( p. 74)
To Next Page
Loading...
Need help?
General
