KTM 990 SUPER DUKE User Manual

RESETTING TRIP 2
The trip meter 2 runs continuously and counts up to 999.9. It can be used similarly to TRIP
1 or together with a switch available as an accessory (see below) for trips according to a
roadbook.
To return the trip meter 2 to zero, switch on the ignition, change to the TRIP 2 mode and
press the SET button.
TRIP F
When the fuel level reaches the reserve mark, the display will automatically switch to TRIP
F and begin to count (no matter which display mode was active before). At the same time,
the fuel warning lamp will light up. You will still have enough reserve fuel for at least 30
kilometers.
After refueling, it will take approx. 8 minutes for the fuel warning lamp to switch off and for
TRIP F to automatically reset to 0 and return to the previous display mode.
NOTE:
Press the SET key for 2 seconds to immediately turn off the fuel warning lamp.
OPERATION INSTRUMENTS »
11
2

KTM 990 SUPER DUKE Specifications

General

Engine Type	V-Twin, 4-stroke
Displacement	999 cc
Bore x Stroke	101 mm x 62.4 mm
Compression Ratio	11.5:1
Fuel System	Electronic fuel injection
Transmission	6-speed
Front Suspension	WP USD 48 mm
Rear Suspension	WP monoshock
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
Dry Weight	186 kg
Fuel Capacity	15 liters
Power	120 hp @ 9, 000 rpm
Torque	100 Nm @ 7000 rpm
Cooling System	Liquid cooled
Frame	Chromium-molybdenum trellis frame
Front Brake	2 x 320 mm discs, 4-piston calipers
Rear Brake	240 mm disc, 2-piston caliper