PTO30
BPTO shaft Cover and Shaft Cap
Keep the PTO shaft cover in place at all times. Replace
the PTO shaft cap when the PTO is not in use. Before
connecting or disconnecting a drive shaft to PTO shaft, be
sure engine is "OFF".
A The universal joint of the PTO drive shaft is technically
limited in its moving angle. Refer to the PTO Drive
Shaft Instructions for proper use.
BStationary PTO
[without Mid PTO type]
To park the tractor and use the PTO system (for chipper
or pump, for example), start the PTO system in the
following steps.
1. Apply the parking brake and place blocks at the tires.
2. Make sure the shift levers are at NEUTRAL, and start
the engine.
3. Set the PTO gear shift lever to "Rear PTO ON"
position.
4. Set the engine speed to provide recommended rear
PTO speed.
5. Get off the tractor.
A If the PTO system is engaged and you stand up from
the seat and release the parking brake, the engine
stops automatically after standing up.
(1) PTO shaft cover
(2) PTO shaft cap
(1) Parking brake pedal
(2) Clutch pedal
(A) "DEPRESS"
(1) PTO gear shift lever "ON (540 rpm)"
"NEUTRAL"
"ON (1000 rpm)"
To Next Page
Loading...
Need help?
General
