HYDRAULIC UNIT36
AUXILIARY HYDRAULICS
Hydraulic outlet (rear) is provided on the tractor.
BHydraulic Block Type Outlet
Hydraulic block type outlet is useful when adding
hydraulically operated equipment such as front end
loader, front blade, etc.
When an implement is attached
1. Remove the block cover.
2. Attach the block outlet cover. (option)
[Rear outlet]
Hydraulic outlets are provided on the tractor.
A If the implement control valve has a relief valve, the
tank port flow from implement should be connected to
the port located on the right hand side of transmission
case.
DUAL REMOTE HYDRAULIC CONTROL
SYSTEM
The tractor is equipped with the double-acting 2-segment
hydraulic control valve for the front loader.
To apply the hydraulic power take-off for general
attachments, keep the following point in mind.
BControl Lever and Hydraulic Hose
Connections
Connect the control lever in its specified direction and the
hydraulic hoses to their specified ports.
(1) Block cover
(2) Block outlet cover (option)
(3) Outlet
(4) Inlet
(A) To implement inlet
Max. flow
17.9 L/min
(4.7 U.S.gals./min)
Max. pressure
13.0 to 13.8 MPa
(133 to 141 kgf/cm )
(1891 to 2005 psi)
(B) from implement outlet
(1) Loader / Remote control valve lever (R) "RIGHT"
(L) "LEFT"
(U) "UP"
(D) "DOWN"
Pressure
Returning
Hydraulic outlet ports of first segment
Lever UP DOWN
Port
[A] In Out
[B] Out In
Hydraulic outlet ports of second segment
Lever RIGHT LEFT
Port
[C] In Out
[D] Out In
To Next Page
Loading...
Need help?
General
