TIRES, WHEELS AND BALLAST42
BRear Wheels
[B2320DTN, B2320HSDN]
Rear tread width can be adjusted as shown.
To change the tread width
1. Loosen the nut of cotter pin bolt.
2. Remove the snap pin and wheel hub pin.
3. Change the tread to the desired position.
4. Re-set the wheel hub pin, snap pin and cotter pin bolt.
C USA models
A Always attach tires as shown in the drawings.
A If not attached as illustrated, transmission parts may
be damaged.
A When re-fitting or adjusting a wheel, tighten the bolts
to the following torques then recheck after driving the
tractor forward and backward for 5 minutes and
thereafter on a daily basis.
A Insert the bolt from the indented side of the cotter (C)
as shown.
Tire Models Tread
8 - 16
Farm
B2320
HSDN
B2320
DTN
8.3 - 16
Farm
B2320
HSDN
B2320
DTN
(1) Nut
(2) Spring washer
(3) Bolt
(4) Wheel hub pin
(5) Snap pin
(A) 123 to 147 N-m
(12.6 to 15.0 kgf-m,
91 to 108 ft-lbs)
(B) 108 to 125 N-m
(11.0 to 12.8 kgf-m,
80 to 93 ft-lbs)
(1) Nut
(2) Spring washer
(3) Bolt
(C) Cotter
(D) Cotter
To Next Page
Loading...
Need help?
General
