PERIODIC SERVICE56
[HST Type]
C Preparation before testing.
1. Sit on operator's seat.
2. Set the parking brake and stop the engine.
3. Shift the range gear shift lever to "NEUTRAL" position.
Place the speed control pedal in "NEUTRAL" position.
4. Shift the PTO gear shift lever to "NEUTRAL" position.
5. Fully depress the clutch pedal.
C Test : Switch for the speed control pedal.
1. Fully depress the clutch pedal.
2. Depress the speed control pedal.
3. Turn the key to "START" position.
4. The engine must not crank.
C Test : Switch for the PTO gear shift lever.
1. Fully depress the clutch pedal.
2. Place the speed control pedal in "NEUTRAL" position.
3. Shift the PTO gear shift lever to "ON" (Engaged)
position.
4. Turn the key to "START" position.
5. The engine must not crank.
C Test : Switch for the Operator's seat.
1. Sit on operator's seat.
2. Start the engine.
3. Fully depress the clutch pedal.
4. Shift the PTO gear shift lever to "ON" (Engaged)
position.
5. Stand up. (Do not get off the machine.)
6. The engine must shut off after approximately 1
second.
7. If it does not stop, consult your local KUBOTA Dealer
for this service.
A If the engine cranks during any of these tests, consult
your local KUBOTA Dealer to have unit checked
before operating.
BChecking Wheel Nut Torque
To avoid personal injury:
A Never operate tractor with a loose rim, wheel,
or axle.
A Any time bolts and nuts are loosened, retighten
to specified torque.
A Check all bolts and nuts frequently and keep
them tight.
Check wheel bolts and nuts regularly especially when
new. If they are loose, tighten them as follows.
[B2320DTN, B2320HSDN]
(1) Clutch pedal
(2) Range gear shift lever (L-M-H)
(3) PTO gear shift lever
(4) Speed control pedal
(1) 79 to 92 N-m (8.1 to 9.4 kgf-m, 58.3 to 67.9 ft-lbs.)
(2) 145 to 150 N-m (14.8 to 15.3 kgf-m, 107.0 to 110.6 ft-lbs.)
(1) 123 to 147 N-m (12.6 to 15.0 kgf-m, 91 to 108 ft-lbs)
(2) 108 to 125 N-m (11.0 to 12.8 kgf-m, 80 to 93 ft-lbs)
To Next Page
Loading...
Need help?
General
