TIRES, WHEELS AND BALLAST44
A Always attach tires as shown in the drawings.
A If not attached as illustrated, transmission parts may
be damaged.
[Wheels with beveled or tapered holes]
A Use the tapered side of lug nut.
[Wheels without beveled or tapered holes]
A Use the flat side of the lug nut. Make sure to apply the
spring washer.
BALLAST
To avoid personal injury:
A Additional ballast will be needed for
transporting heavy implements. When the
implement is raised, drive slowly over rough
ground, regardless of how much ballast is
used.
A Do not fill the front wheels with liquid.
BFront Ballast
Add weights if needed for stability and improving traction.
Heavy pulling and heavy rear mounted implements tend
to lift front wheels. Add enough ballast to maintain
steering control and prevent tip over.
Remove weight when no longer needed.
C Front End Weights (option)
The front end weights can be attached to the bumper.
See your implement operator's manual for required
number of weights or consult your local KUBOTA Dealer
to use.
A Besides the weight, a mounting kit is also required.
A Do not overload tires.
A Add no more weight than indicated in chart.
(1) 145 to 150 N-m (14.8 to 15.3 kgf-m, 107.0 to 110.6 ft-lbs)
(1) Lug nut
(1) Lug nut
(2) Spring washer
(1) Front end weights
(2) Bumper
Maximum weight
25 kg x 3 pieces
( 165 lbs )
To Next Page
Loading...
Need help?
General
