Kubota BX1880 - Operating the Tractor; New Tractor Break-in Procedures; Mounting;Dismounting and ROPS Operation

4. Place the
speed-control-pedal in the neutral
position.
(1) Speed control pedal
NOTE :
• The speed-control-pedal
automatically
returns to the neutral position when the
operator's foot is released from the pedal.
5. Place the range-gear-shift-lever (Hi-Lo) in the
neutral “N” position.
(1) Range gear shift lever (Hi-
Lo)
(A) Low
(B)
Neutral
(C) High
6. Place the lock lever in the lock
position to lock the
auxiliary-hydraulic-control-lever if the tractor is
equipped with the auxiliary-hydraulic-control-lever.
(1) Auxiliary hydraulic control
lever
(2)
Lock lever
(A)
Lock
7. Move
the hydraulic control lever forward (lowered
(down)
position) to lower the implement.
(1) Hydraulic control lever
(A) Lowered
(B)
Neutral position
(C) Raised
Check that the implement is down at the lowest
position after
moving the hydraulic control lever
forward.
8. Set the hand-accelerator-lever to about 1/2 way.
(1) Hand accelerator lever
(A) Increase
(B)
Decrease
OPERATING THE ENGINE STARTING THE ENGINE
38
BX1880, BX2380, BX2680