25PERIODIC SERVICE
ENGLISH
*90 mm (3.54 in.) oil pan depth is optional.
Oil quantities shown are for standard oil pans.
*API service classification: above CF grade
A Engine oil should be MIL-L-2104C or have
properties of API classification CF or higher.
Change the type of engine oil according to the
ambient temperature.
A When using oil of different brands from the previous
one, be sure to drain all the previous oil before
adding the new engine oil.
A Be sure to inspect the engine, locating it on a level
place. If placed on gradients accurately, oil quantity
may not be measured.
BChanging engine oil
CAUTION
To avoid personal injury:
A Be sure to stop the engine before
draining engine oil.
A When draining engine oil, place
some container underneath the
engine and dispose it according to
local regulations.
A Do not drain oil after running the
engine. Allow engine to cool down
sufficiently.
1. Change engine oil. (Refer to page 13)
2. Remove the drain plug at the bottom of the engine,
and drain all the old oil. Drain oil will drain easier
when the oil is warm.
3. Add new engine oil up to the upper limit of the oil
level gauge.
Models
Oil pan depth
124 mm (4.88 in.) *90 mm (3.54 in.)
D1503-M-E3
D1703-M-E3
D1803-M-E3
7.0 L
(1.85 U.S.gals.)
5.6 L
(1.48 U.S.gals.)
D1803-M-DI-E3 –
V2003-M-E3
V2203-M-E3
V2403-M-E3
V2403-M-T-E3
9.5 L
(2.51 U.S.gals.)
7.6 L
(2.01 U.S.gals.)
V2403-M-DI-E3 –
Models Quantity
V3600-E3, V3600-T-E3,
V3300-E3BG,
V3600-T-E3BG
13.2 L (3.49 U.S. gal.)
above 25°C (77°F)
SAE30 or SAE10W-30
SAE15W-40
-10°C to 25°C (14°F to 77°F) SAE10W-30 or SAE15W-40
below -10°C (14°F) SAE10W-30
(1) Oil drain plug
To Next Page
Loading...
Need help?
General
