26 PERIODIC SERVICE
ENGLISH
BReplacing the oil filter cartridge
CAUTION
To avoid personal injury:
A Be sure to stop the engine before
changing the oil filter cartridge.
A Allow engine to cool down
sufficiently, oil can be hot and cause
burns.
1. Replace the oil filter cartridge. (Refer to page 13)
2. Remove the old oil filter cartridge with a filter wrench.
3. Apply a film of oil to the gasket for the new cartridge.
4. Screw in the cartridge by hand. When the gasket
contacts the seal surface, tighten the cartridge
enough by hand. Because, if you tighten the
cartridge with a wrench, it will be tightened too much.
[Z482-E3, Z602-E3, D722-E3, D782-E3, D902-E3,
D1005-E3, D1105-E3, D1105-TE3, D1305-E3, V1505-E3,
V1505-TE3, D1005-E3BG, D1105-E3BG, V1505-E3BG]
[D1503-M-E3, D1703-M-E3, D1803-M-E3, V2003-M-E3,
V2203-M-E3, V2403-M-E3, V2403-M-T-E3, D1803-M-DI-E3,
V2403-M-DI-E3]
[V3600-E3, V3600-T-E3, V3300-E3BG, V3600-T-E3BG]
5. After the new cartridge has been replaced, the
engine oil level normally decreases a little. Thus, run
the engine for a while and check for oil leaks through
the seal before checking the engine oil level. Add oil
if necessary.
A Wipe off any oil sticking to the machine completely.
(1) Oil filter cartridge
Remove with a filter wrench
(Tighten with your hand)
(1) Oil filter cartridge
(2) Remove with a filter wrench
(Tighten with your hand)
(1) Oil filter cartridge
To Next Page
Loading...
Need help?
General
