PERIODIC SERVICE30
ENGLISH
No.2-D is a distillate fuel oil of lower volatility for engines
in industrial and heavy mobile service.
(SAE J313 JUN87)
Grade of Diesel Fuel Oil According to ASTM D975
The cetane number is required not to be less than 45.
A Be sure to use a strainer when filling the fuel tank, or
dirt or sand in the fuel may cause trouble in the fuel
injection pump.
A Always use diesel fuel. You are required not to use
alternative fuel, because its quality is unknown and
affect the generator performance. Kerosene, which is
very low in cetane rating, adversely affects the engine.
Diesel fuel differs in grades depending on the
temperature.
A Be careful not to let the fuel tank become empty, or air
can enter the fuel system, necessitating bleeding
before next engine start.
BAir Bleeding the Fuel System
To avoid personal injury;
A Do not bleed a hot engine as this
could cause fuel to spill onto a hot
exhaust manifold creating a danger
of fire.
Air bleeding of the fuel system is required if;
A after the fuel filter and pipes have been detached and
refitted;
A after the fuel tank has become empty; or
A before the engine is to be used after long storage.
[PROCEDURE]
1. Fill the fuel tank to the fullest extent. Open the fuel
filter cock.
2. Loosen air vent plug of the fuel filter a few turns.
3. Screw back the plug when bubbles do not come up
any more.
4. Open the air vent plug on top of the fuel injection
pump.
5. Retighten the plug when bubbles do not come up any
more.
Model Capacity
J106, J107
[Engine model : Z482-B]
37 (9.8)
J108, J110, J310, J313
[Engine model : D722-B]
J112, J114, J315, J318
[Engine model : D1005-BG]
J116, J119, J320, J324
[Engine model : V1305-BG]
79 (20.9)
L (U.S.gal.)Fuel tank capacity
(1) Fuel filter cock
(2) Air vent plug
(3) Fuel filter pot
(A) "OPEN"
(B) "CLOSE"
To Next Page
Loading...
Need help?
General
