33PERIODIC SERVICE
ENGLISH
4. If the oil level is too low, remove the oil port, and add
new oil to the prescribed level.
5. After adding oil, wait more than 5 minutes and check
the oil level again. It takes some time for the oil to drain
down to the oil pan.
6. If the engine is operated with the oil level nearing the
lower limit, the oil may deteriorate more quickly than
normal, therefore, keeping the oil level near the upper
limit is recommended.
Engine oil capacity L (U.S.qts.)
A Engine oil should be MIL-L-2104C or have properties
of API classification CF grades or higher.
Change the type of engine oil according to the
ambient temperature.
A When using oil of different brands from the previous
one, be sure to drain all the previous oil before adding
the new engine oil.
BChanging Engine Oil
To avoid personal injury:
A Be sure to stop the engine before
draining engine oil.
A When draining engine oil, place a
suitable container underneath the
engine and dispose of it according to
local regulations.
A DO NOT drain oil from a hot engine.
Allow engine to cool down
sufficiently to avoid being burned.
1. Change oil after the initial 50 hours of operation and
every 100 hours thereafter.
2. Remove the drain plug to drain the engine oil. Drain all
the old oil, drains easier and completely when the
engine is warm. Inspect drain plug gasket. Replace if
damaged.
[Engine model : Z482, D722]
[Engine model : D1005, V1305]
3. Install the oil drain plug and gasket.
4. Add new engine oil up to the upper line of the oil level
gauge.
Model Capacity
J106, J107
[Engine model : Z482-B]
2.2 (2.3)
J108, J110, J310, J313
[Engine model : D722-B]
3.4 (3.6)
J112, J114, J315, J318
[Engine model : D1005-BG]
4.3 (4.5)
J116, J119, J320, J324
[Engine model : V1305-BG]
5.7 (6.0)
(1) Engine oil drain plug
To Next Page
Loading...
Need help?
General
