To Next Page

To Previous Page

REMOVING

THE

LOADER

REMOVING

THE

LOADER

WARNING

avoid

serious

injury:

•

iVIake

sure

approved

bucl<et is

attaciied

before

removing

the

loader

from

tiie

tractor.

• For removing

the

loader,

choose

flat

and

hard

ground,

preferably

concrete.

• If

the

ground

surface

is soft,

place

suitable

planks on

the

ground

for

the

bucket

and

stands.

•

Before

starting

the

engine

using

the

hydraulic

control

valve, always

sit

the

operator's

seat.

•

Make

sure

the

bucket

and

stands

are

ground

level.

Raise

the

boom

until

the

stands

can

rotated.

Stop

the

engine.

Remove the spring pins holding the

stands

to the

boom.

Slide

the

stands

leftward

and

rotate

them

until

the

hole

in the

stand

and pin on the boom

are

aligned. Then

slide the stands rightward and insert the spring pin

shown.

1AIABCPAP005A

(1)

Stand

(2)

Spring

5. Start

the

engine

and

run at idle.

6. Dump

the

bucket approximately 20

degrees.

7. Lower

the

boom

and

raise

the

front

wheels

slightly.

1AABDDAP004A

(1)

Stand

IMPORTANT:

•

Lift

the weight offthe front wheels withthe bucket. Do

not attempt to lift

them

with

the

stands.

Stop

the

engine.

9. Remove the mounting pins from

the

loader main frame

and

store

them

boom.

10.Start the engine and run at idle. Slowly move the

hydraulic control lever to rollback position to raise the

loader side frames up and out of the receivers of the

main

frames

shown.

1AIABCPAP007A

Brand	Kubota
Model	LA434
Category	Front End Loaders
Language	English

Kubota LA434 User Manual

Table of Contents

Questions and Answers:

Kubota LA434 Specifications

Related product manuals