(1) Fuse box with slow-blow fuse box
NOTE :
• Use the correct fuse label when replacing the
fuse cover.
(20) Fuse
(21) Fuse puller
(A) Front
Protected circuit
Fuse No.
Capacity
(A)
Protected circuit
1 20 Radiator fan motor
2 10 Cooling fan motor
3 5 Horn sw
4 10 Hazard lamp
5 10 ECU
6 5 Aux, back buzzer, combi sw
7 15 Power outlet
8 10 Brake lamp sw, meter
9 15 Work light
10 10 Head light
11 10 Meter, speed meter
12 5
Parking brake lamp, oil pressure
lamp, diagnosis lamp
13 50 Key switch
14 60 Key switch
15 5 Spare fuse
16 10 Spare fuse
17 － Fuse puller
18 15 Spare fuse
19 20 Spare fuse
4. Replacing slow-blow fuses
The slow-blow fuses are intended to protect the
electrical cabling. If any of them have blown out, be
sure to pinpoint the cause. Never use any substitute,
use only a Kubota genuine part.
Replacement procedure
1. Disconnect the negative cable of the battery.
2. Remove the cover and the slow-blow fuse box
cover.
3. Pull out the slow-blow fuse.
4. Insert a new slow-blow fuse into the slow-blow fuse
box.
5. Install the slow-blow fuse box cover.
6. Connect the negative battery cable.
Protected circuit
See no.13 and no.14 in the previous table.
SERVICE AS REQUIRED PERIODIC SERVICE
To Next Page
Loading...
Need help?
General
