Kubota WSM LA271 User Manual

-
::.:: ....I
~J
'--
~
I
I
SERVICING
12010F00750
Slide Jig
12010F00760
Correcting
Jig
B
o 0
E F
G
LA271 • LA301 • LA351 • LA401 • LA272· LA302' LA352' LA402 WSM, 17021
Piston Seal and O-ring
1. Remove the piston seal (2) and a-ring (3) from the piston (1) .
• IMPORTANT
• When installing
the O-ring (3) and piston seal (2) to the
piston (1), use the slide jig and correcting jig
as shown in
the figure,
~
LA271 / LA301 / LA272 / LA302 LA351 / LA401 / LA352 / LA402
A
80.y 80.y
B
3' 3'
0.0523 rad. 0.0523 rad.
C
37.46 mm 43.8 mm
1.475 in. 1.724
in.
D
39.46 mm 45.8 mm
1.554 in. 1.803 in.
E
76.0 mm 75.5 mm
2.992 in.
2.972 in.
F
14.0
mm 14.5 mm
0.551 in.
0.571 in.
G
100.0 mm
100.0 mm
3.937 in.
3.937 in.
H
70.0 mm 70.0 mm
2.756 in.
2.756 in.
I
110.0 mm
110.0 mm
4.331 in.
4.331 in.
J
3'
3'
0.0523 rad.
0.0523 rad.
K
38.1 mm 44.45 mm
1.5 in. 1.75 in.
L
47.63
mm
55.0 mm
1.875 in.
2.165 in.
Installing O-ring and Piston Seal
1. Place the slide jig (2) on the piston (4).
2. Install the a-ring (3) on the piston using the slide jig.
3. Install the piston seal (1) over the a-ring using the slide jig.
4. Compress the piston seal to the correct size by installing the
piston into the correcting jig (5).
• NOTE
• Do not turn (roll) the piston seal
as you install it.
12010F00770
12010F00780
2
@@
®
(1) Piston
(2) Piston Seal
(1) Piston Seal
(2) Slide Jig
(3) O-ring
(3) O-ring
(4) Piston
(5) Correcting Jig
17021S00090
12010F00790
I
iii
I
'--
"
S-14
12010S00460
WWW.PlanDeGraissage.ORG

Kubota WSM LA271 Specifications

General

Brand	Kubota
Model	WSM LA271
Category	Compact Loader
Language	English