1-S47
ZD321, ZD326, ZD331, WSM
ENGINE
(4) Flywheel and Crankshaft
Flywheel
1. Secure the flywheel to keep it from turning, using a flywheel
stopper.
2. Remove all flywheel screws (1) and then remove the flywheel (2).
(When reassembling)
• Align the “1TC” mark (a) on the outer surface of the flywheel
horizontally with the alignment mark. Now fit the flywheel in
position.
• Apply engine oil to the threads and the undercut surface of the
flywheel screw and fit the screw.
W10290240
Tightening torque Flywheel screw
54 to 58 N·m
5.5 to 6.0 kgf·m
40 to 43 lbf·ft
(1) Flywheel Screw
(2) Flywheel
(a) 1TC Mark
To Next Page
Loading...
Need help?
General
