G-19
ZD321, ZD326, ZD331, WSM
G GENERAL
[3] CHECK POINT OF INITIAL 100 HOURS
Adjusting Front Axle Pivot
1. Lift up and securely block the front of the machine.
2. Measure the clearance (A) between the front axle (4) and front
axle support (3).
3. If the measurement exceeds the allowable limit, remove the set
spring and adjust the end play by slotted nut (1).
• When fastening the center pin (2), tighten the nut (1) so that
the front axle maybe oscillated smoothly by hand.
W1053511
Front axle end play (A)
Factory spec.
0 to 0.2 mm
0 to 0.008 in.
Allowable limit
0.5 mm
0.02 in.
(1) Slotted Nut
(2) Center Pin
(3) Front Axle Support
(4) Front Axle
(5) Plain Washer
(A) Front Axle End Play
To Next Page
Loading...
Need help?
General
