Kubota ZD221 User Manual

PERIODIC SERVICE44
ENGLISH
BInflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it and inflate as necessary.
BChecking Transmission Fluid Level
1. Park the machine on a flat surface, lower the
implement to the ground and shut off the engine and
remove the key.
Allow the machine to idle for 1-3 minutes, and then
check fluid.
2. Raise and lock the operator's seat.
3. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the two notches.
If the level is too low, add the new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
A If oil level is low, do not run engine.
Tire sizes
Recommended Inflation
Max. Pressure
Front
13 x 5.0 - 6,
4PR Rib
276 kPa
(2.8 kgf/cm , 40 psi)
Rear
23 x 10.5 - 12,
4PR Turf
140 kPa
(1.4 kgf/cm , 20 psi)
(1) Ground (A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
(1) Oil level dipstick (A) Oil level is acceptable
(2) Oil plug and breather cup within this range.

Kubota ZD221 Specifications

General

Style	Zero Turn
Color	Red
Cutting Width	48/54 in
Cutting Height	1-5 in
Cutting Method	-
Number of Blades	3
Drive System	Cruise Control (Hydrostatic)
Case Size: U1R	CCA: 450A
Noise Level	-
Features	Superior Quality Cut
Accessories	-
Motor / Engine Model	Kubota D782
Power Output	-
Cylinders	3
Generator	-
Power / Fuel Type	Diesel
Fuel Tank Volume	23.0 liters (6.1 US gal.; 5.1 Imp. gal)
SAE 5W30 (below 32°F/0°C)	SAE 5W30
w/o Filter: 44 oz. (1	1.32 Imp. qt.)

Weight and Dimensions

Depth	2130 mm (83.9 in)
Height	1770 mm (69.7 in)
Width	1210 mm (47.6 in)
Net Weight	550 kg (1213 lbs)