KYMCO PEOPLE 125 User Manual

12. FRONT WHEEL/FRONT BRAKE/
FRONT SUSPENSION
12-8
PEOPL E 12 5/150
HYDRAULIC BRAKE (FRONT
BRAKE)
BRAKE FLUID REPLACEMENT/AIR
BLEEDING
Check the brake fluid level on level ground.
BRAKE FLUID BLEEDING
In order to avoid spilling brake fluid, connect
a transparent hose to the bleed valve.
Fully apply the brake lever and then loosen
the brake caliper bleed valve to drain the
brake fluid until there is no air bubbles in the
brake fluid. Then, tighten the bleed valve.
Repeat these steps until the brake system is
free of air.
BRAKE FLUID REFILLING
Add DOT-3 brake fluid to the brake
reservoir.
Make sure to bleed air from the brake system.
BRAKE PAD/DISK REPLACEMENT
Remove the two bolts attaching the brake
caliper.
Remove the brake caliper.
Compress the brake caliper seat, and press
down the fixed-reed to take out the brake
pads.
• When operating the brake lever, the
brake reservoir cap must be tightened
securely to avoid splash of brake fluid.
• When servicing the brake system, use
shop towels to cover plastic parts and
coated surfaces to avoid damage caused
by splash of brake fluid.
＊
Spilled brake fluid on brake pads or brake
disk reduces stopping power. Clean the
brake pads and brake disk with a high-
performance brake degreaser.
Warning
• When bleeding, be careful not to allow
air in the brake reservoir flowing into
the brake system.
• Never use dirty or unspecified brake
fluid or mix different brake fluids be-
cause it will damage the brake system.
＊
The brake pads must be replaced as a set
to ensure the balance of the brake disk.
＊
Hose
Lower Limit
Front Brake Caliper
Reservoir
Fixed-Reed
www.PlanDeGraissage.org

KYMCO PEOPLE 125 Specifications

General

Brand	KYMCO
Model	PEOPLE 125
Category	Motorcycle
Language	English