FLOAT LEVEL INSPECTION
Measure the float level.
Float Level: 18.5mm
Float Level Gauge
CARBURETOR INSTALLATION
Tighten the drain screw.
Install the carburetor onto the intake
manifold, aligning the tab on the carburetor
with the cutout in the intake manifold.
Tighten the band screw.
Install the air cleaner connecting tube and
tighten the band screw.
Connect the throttle cable to the throttle
wheel on the carburetor.
Connect the fuel tube and vacuum tube to the
carburetor.
Connect the auto bystarter wire connector.
Perform the following inspections and
adjustments:
-Throttle grip free play (
!
3-3)
-Carburetor idle speed (
!
3-6)
• Check the operation of the float valve
and float before float level inspection.
• Measure the float level by placing the
float level gauge on the float chamber
face parallel with the main jet.
To Next Page
Loading...
Need help?
General
