- 16 -
(10) HORN/LIGHTS INSPECTION
y Turn the ignition switch “ON” and press the horn
button to check if it sounds.
y Headlight/Taillight Inspection:
Start the engine and turn on the headlight switch
to check if the headlight and taillight are good
and check the light shells for dirt and damage.
y Stoplight Inspection:
Apply the front and rear brake levers respectively
to check if the stoplight is good. And also check
the stoplight shell for dirt and damage.
y Turn Signal Light Inspection:
Operate the turn signal switch to make sure
whether the right/left front and rear turn signal
lights can wink and buzz. Also check the light
shells for dirt and damage.
c Headlight d Turn signal light e Taillight/
Stoplight f Horn button
n CAUTION:
y Replace any dirty or damaged lights with new
ones to avoid danger during riding.
c
d
e
f
To Next Page
Need help?
General
