- 31 -
(4) BATTERY
y This model adopts the battery which needs no
refilling of distilled water.
y When cleaning the terminal terminals, remove the
screws attaching the battery cover on the floor
board and then open the battery cover.
y When battery terminals are corroded, take out the
battery for cleaning.
y After cleaning, apply a thin coat of grease or
Vaseline to battery terminals and then install the
battery.
n CAUTION:
y Never open the closed-type battery electrolyte
cap.
y If the motorcycle will not be used for a long time,
the battery will discharge electricity by itself.
Remove the battery and put it in a cool place after
it is fully charged to prevent electricity leakage.
y If the motorcycle will not be used for a long time,
remove the negative (-) terminal.
y Do not smoke or allow flames or sparks near the
battery while removing and installing it.
y Turn off the ignition switch before removal or
installation. The negative (-) terminal shall be
removed first and the positive (+) terminal shall be
installed first.
y Tighten the loose terminal nuts securely.
Battery
To Next Page
Loading...
Need help?
General
